Star Wars Death Star LED Night Light | 3D printed Lithophane | Wall Plug for Bedroom, Bathroom, Hallway | Dusk to Dawn operation
SShow off your Star War addiction with this 3D printed night lamp. Comes with or without Star Destroyer figure. The printed Lithophane changes the thickness of the light to show the details of the model. Great for any room! The LED light has a Dusk/Dawn sensor to turn the light off during the day. The light is roughly 4 inches wide. The Star Destroyer fits snug on the base but would recommend some glue to avoid it being knocked out. Pro tip: Twist the light 90 degrees to remove or place on the Death Star.
Disclaimer: 3D printed designs may have small imperfections due to the printing process. Every effort is made to print high-quality products with the best filament. But note, the way they are manufactured on the 3D printer creates layer lines. Therefore, the product is not completely smooth.
SShow off your Star War addiction with this 3D printed night lamp. Comes with or without Star Destroyer figure. The printed Lithophane changes the thickness of the light to show the details of the model. Great for any room! The LED light has a Dusk/Dawn sensor to turn the light off during the day. The light is roughly 4 inches wide. The Star Destroyer fits snug on the base but would recommend some glue to avoid it being knocked out. Pro tip: Twist the light 90 degrees to remove or place on the Death Star.
Disclaimer: 3D printed designs may have small imperfections due to the printing process. Every effort is made to print high-quality products with the best filament. But note, the way they are manufactured on the 3D printer creates layer lines. Therefore, the product is not completely smooth.
SShow off your Star War addiction with this 3D printed night lamp. Comes with or without Star Destroyer figure. The printed Lithophane changes the thickness of the light to show the details of the model. Great for any room! The LED light has a Dusk/Dawn sensor to turn the light off during the day. The light is roughly 4 inches wide. The Star Destroyer fits snug on the base but would recommend some glue to avoid it being knocked out. Pro tip: Twist the light 90 degrees to remove or place on the Death Star.
Disclaimer: 3D printed designs may have small imperfections due to the printing process. Every effort is made to print high-quality products with the best filament. But note, the way they are manufactured on the 3D printer creates layer lines. Therefore, the product is not completely smooth.